- Happy with service
- Slightly Burnt Syrup Pan
- Air injection in the syrup pan
- Burned pans
- Final draw- how do you salvage the last syrup?
- No sheeting, lots o syrup
- Looking to upgrade need some advice
- Drop flue vs Raised Flue
- Pallet Carving - How do you do it?
- reverse flow in the flue pan
- Brushing soot off raised flue pans
- Why is my 2x6 going slow
- using barometers
- what happens if there is rust in the pan
- Cleaning Pans?
- Patrick Phaneuf Evaporators
- efficiency question
- Ham Nord
- cleaning flues
- Steam hood
- Lining a cinder block evaporator
- how many cords of wood has everyone gone through
- how to repair a tin pan
- New 2x6 Small Bros - Optimum Setup?
- do oil fired evaporators have to have a stack
- making evaporators for a living
- bubbler
- when the process is done
- painting arch?
- gph on a 6x6 syrup pan
- how many of you guys have burnt a pan in your lifetime
- old stone or brick arches
- Fixing warped pan
- raisable grates
- hobby evaporators
- Have a cupola now want a steam hood but have a question
- gimm wood saver do they work
- Question about roof jacks
- Recovering steam / water
- smoke stack to close
- steam hood venting
- raised flue gap between flue pan and insulation
- to much draft
- What to do?
- The Max evaporator by Leader
- Firewood question
- 4-wheeler parts
- large producers
- opinions on evaporators
- Burning tamarack
- Pin Hole
- Inferno, intens-o-fire how to?
- preheater connector hose
- Filter press test
- arch
- float
- waste oil and alternative fuels
- steamaway
- Air Tight Doors
- gallons for 3X10
- Pan dividers in small pan
- low tech/cheap options
- stack dia. for 3x10
- how long until boil?
- repairs to pans
- Pre-heater question
- Smoke stack question
- Cleaning burnt stuff
- Forced air options
- double boiler
- steam hood plans
- Leader WSE rig
- Home made steam away
- Forced Air Again
- buying sap
- Rock Wool
- Old arch with sliding draft
- value of 2x4 oil
- 2'x6' small brothers lightning
- smokestack
- How do you know if there is lead in a pan?
- stack size
- Evaporators 101 course
- Arch door
- Removing Firebricks
- pan for sale on ebay
- high temp caulk
- Syrup pan question
- smokestack 1 more time
- smoke stack size
- hole in pan
- cleaning sand while boiling
- steam stack size
- Bricking Instructions???
- stainless polish
- Leader Vermont Special
- Raised flue vs drop flue
- value in evaporators
- building 3x10 arch
- Songs
- cheap smoke stack
- How to keep the stack up?
- To raise or not to raise the arch
- automatic draw off
- She said YES
- small evaporator on a wood floor?
- Gordan-Piatt Burner
- insulating your pans
- 18 x 48 Dallaire
- pan gasket
- building a flue pan from scratch
- Air injector (bubbler)
- Air injector (bubbler)
- 2x5 evaporator
- Marcland set up info
- temp alarm with barometric correction
- blower "squeeling"
- Basic Blower Question
- Cleaning pans WHILE boiling
- i need help
- pre season cleaning
- Lapierre Auto Draw off
- Cross-flow and Reversing
- Where Did I Go Wrong?
- vermiculite
- Maple Pro evaporators
- roof jacks and fire risk
- Bricking arch with flue clean out
- morter or not
- need lesson on 300vs400 stainless
- New Evaporator: brick and insulation suggestions needed
- Substitute for Flue Brush
- Any ice safe?
- Thermometers
- hood issue
- Burning scrap crap
- 3x10 king
- Forced draft question
- flue pan construction
- questions on small brothers 2x6 pans
- holes in my flue pans
- Float Valve
- Humidity
- flu brush.
- Evaporator Freezing?
- maintianing gradient
- Witch is better raised or dropped flues
- Bricking tips urgently needed!
- Used Leader evaporator for sale
- First time with new 2x6 - not so good!
- info on raised flue
- steamaway vs piggyback vs more RO membranes
- Sugarin' the Pan
- Steam Stack Height
- Drop flu Question???
- Need idea's on raised flue setup
- parts and definitions?
- pan cleaning
- pan gasket
- Value of 2x4 Vermont Special
- Drawoff Container Type?
- Building a supercharger for my 2X6.
- evaporation rate
- JB weld in pan????!!!!!!!!
- Weld a soldered pan
- First timer - Advice needed
- Pan for Barrel Arch
- Pan wanted
- copper pans
- Bricking a new arch
- Arch Insulation
- Missed A great deal...
- Steam Management in Sugarhouse
- Tuning my Leader 2x4 WSE
- sweetening pans...
- Cement Board in Arch??
- Drawing off
- Evaporator done! Pan dilema
- Commercial outsider on our forum ?
- Just not hot enough
- Near diaster
- Scorching temp?
- Drop Flue Evaporator Pan
- Steam hood drip collection
- Boiling Rate
- whats the minimum taps to feed a 2X8?
- Maple Syrup Evaporator Arch 2x8 for sale on ebay
- Low boil temp? 200 F
- Computers
- 3x8 draft
- New Evaporator Arrives
- Missed ???
- blower on 3x8 wood fired
- Used 2'x6' arch and 2'x4' flue pan ?
- Pre-heater question
- Stack temps
- Oh Man!
- new 1/2 pint questions...
- dirty syrup and pans
- Help!
- Leaking Leader Flue Pan
- Ultraviolet Light
- Got it right - I think!
- ebay
- 100 Gallons of Syrup
- New website for Patrick Phaneuf Evaporators
- Firebrick question
- Oli pressure
- pre heater evaporation
- Pan siphon ?
- It worked!
- Marcland auto drawoff
- Blower Question
- frozen sap in float box
- Evaporation Rate
- 1/2 pint is a flame thrower!
- Home made tube drop flue
- A different blower question
- Disapointing rate
- Dropped/Raised Flue Pan
- Propane burners / pre heater
- Bulk Pricing
- Help me Repair my Stack! Please
- going to try it
- Jacking Sap,
- Wind shift shut me down
- stack temp
- Types of Flue Pans?
- cold draw of compartment
- Replacing double arch doors?
- Pre heat??
- hole in tank
- Measuring evaporation rate
- Grates
- Arch Sheet Metal
- Chasing the sweet--really?
- Used 2'x4' Leader Evaporator
- Running Temp???
- How often are you guys cleaning syrup pan?
- too much defoamer
- Cleaning/White vinegar question
- Low surgar
- Sap level in pan
- Stack Size
- Venting pipe for evap.
- Cooking times/Sugar Content/Grade
- oil arches
- syrup pan question
- Help !! With Front Pan Locking
- Dominion & Grimm Open House?